[19451] Gun Bluster XTO ~ Premium Version (FM-A Chassis) [里歐・庫斯科 ~ 鋼布拉斯達 XTO]

[Full cowl body with sharp edge creates powerful running! ]

This is a plastic model assembly kit of a high-performance racer that uses shaft drive four-wheel drive.

The Gun Blaster XTO Premium is a premium version of the Gun Blaster XTO that appeared in the 1997 movie "Bakuso Kyodai Let's & Go!! WGP Runaway Mini 4WD Great Tracking!"

It features a cowl that fully covers the front and rear tires, a cockpit side that is narrowed down, and an arched rear wing that regulates the flow of wind.

The body is made of blue ABS resin.

Markings and headlights with graphics that change from yellow to red based on black are prepared with metallic stickers.

[Adopts FM-A chassis with front motor layout]

The chassis uses FM-A with a front motor layout that incorporates an aero design.

The center of gravity is located closer to the front of the body, so it is possible to run with a sense of stability even on courses with many ups and downs.

In addition to the standard low-friction resin skid bar at the bottom of the front, the four rollers are also made of low-friction resin.

In particular, the rear roller is an 8 mm thick type that enhances stability.

In addition, the motor can be easily replaced from the bottom of the chassis, allowing speedy setting changes.

Various parts can be attached to the aero side stay, which is inspired by the cross-sectional shape of an airplane wing.

The chassis body is made of ABS resin, and the A parts such as the under panel and skid bar are made of blue low-friction resin.

Small-diameter low-height tires (black) are attached to the spiral 6-spoke wheels with vivid red color.

3.5:1 super speed gear with motor.

[Basic specifications]

● Total length when completed: 155 mm ● Width: 97 mm ● Height: 37 mm

● Single shaft motor included ● Assembly is an inset type that does not require adhesive

[Separately purchased]

● 2 AA batteries